Pages: [1]   Go Down

Author Topic: Please bear with us  (Read 10 times)

0 Members and 1 Guest are viewing this topic.

Offline Critterman

  • Retired, thank you very much
  • Premium Member
  • General Manager
  • *
  • Posts: 13703
  • Karma: +18/-58
  • Baltimore/Washington Corridor
Please bear with us
« on: Today at 01:06:56 PM »
Last week the board crashed and since this is a privately owned and maintained board it will take a while to get it back to where it was before.  Problem is unknown at this time but Joe had to load a clean version of the board.  It will take him a while to get it up to where it was before.  Please bear with him.

Thank you,
Critter.
Logged
GONE: (but not forgotten) 2006 Cool named IXABEL (BISH-AH-BEL) Mayan for "Good Roads"
DDM StageIII intercooled Supercharger, Wisco ceramic coated pistons, Carrillo rods, superTech valves and Springs, Ported and polished head, Exedy Stage II Clutch,
big brake kit, slotted/drilled Rotors w/Porterfield pads & blue juice, Backbone, Probeam, Cross Strut Brace Underhood, trunk, & door Lights, ZOK suspension
JPM Center console, door inserts, & dash Seat bolster & lumbar support
Focuztech Tri-Y Header & hi-flow cat, Solo Performance SQR-2, Norm's Rear facia, Heated Seats, Blackface gau

Offline Sol Asylum

  • Premium Member
  • General Manager
  • *
  • Posts: 10382
  • Karma: +40/-66
  • My car identifies as transportation
Re: Please bear with us
« Reply #1 on: Today at 08:53:27 PM »
GJ I know you want to make a juvenile comment about Critter saying it was going to take Joe a while to get it up.  But we should probably try to be more mature than that.  Besides they make a pill for that, and I would have expected Critter to tell Joe what worked best for him.  I mean figuring out what worked best for him can't be that hard. :poke:
Logged
2007 Aggressive GXP
Pages: [1]   Go Up