« on: May 05, 2009, 12:32:13 PM »
I need you to open your trunck, and at the back where the hinges meet the body work when the trunck is open to it's full extend, there should be rubber bump stops. These will be located on the underside of the body work where the hinge meets the body. I need to know how thick your stops are, mine are less than an 1/8 of an inch and I want to know if later years have thicker stops because of the spoiler.
Thanks,
John
« Last Edit: May 06, 2009, 08:13:00 PM by DeepBlueGXP »

Logged
GONE: (but not forgotten) 2006 Cool named IXABEL (BISH-AH-BEL) Mayan for "Good Roads"
DDM StageIII intercooled Supercharger, Wisco ceramic coated pistons, Carrillo rods, superTech valves and Springs, Ported and polished head, Exedy Stage II Clutch,
big brake kit, slotted/drilled Rotors w/Porterfield pads & blue juice, Backbone, Probeam, Cross Strut Brace Underhood, trunk, & door Lights, ZOK suspension
JPM Center console, door inserts, & dash Seat bolster & lumbar support
Focuztech Tri-Y Header & hi-flow cat, Solo Performance SQR-2, Norm's Rear facia, Heated Seats, Blackface gau