Welcome Guest!!!

Thank you for visiting the GM Kappa Performance Forum. This forum is the only performance oriented forum for all GM Kappa Platform Enthusiasts.  We hope you will join and share your experiences.  Becoming a member is FREE! If you want to advertise on this forum, email KappaPerformance at yahoo.com.

Registration required to view the forum attachments. Below is a sample of the current top 25 topics.
Supporting Membership has many advantages.

More information on becoming a supporting member or vendor can be found on the sub forum; Site Help and Suggestions; thread - Supporting Members and Vendors.
Pages: [1]   Go Down

Author Topic: DIC reading zero  (Read 2325 times)

0 Members and 1 Guest are viewing this topic.

Offline Jim

  • Premium Member
  • Master Tech
  • *
  • Posts: 406
  • Karma: +13/-4
DIC reading zero
« on: April 16, 2014, 03:55:02 PM »
Getting ready for my turbo upgrade next week and decided to install the 3 bar map sensors (with harnesses so they were plug and play). Loaded the 3 bar map info in the Engine Diagnostics (Airflow) section in HP tuners, loaded the calibration and took it for a spin. It still builds boost fine but the DIC shows 0 the entire time. Didn't want to risk anything so I parked it and am looking for a fix. I checked all of the plugs and pins and they look like they should. Any ideas?

Thanks in advance!
Logged
The road to success is always under construction.

Offline Jim

  • Premium Member
  • Master Tech
  • *
  • Posts: 406
  • Karma: +13/-4
Re: DIC reading zero
« Reply #1 on: April 16, 2014, 06:02:53 PM »
It's a bad sensor - new but bad.... I switched them around and got a P0107 code. Switched back to my 2.5 bars for now.
Logged
The road to success is always under construction.
Pages: [1]   Go Up
 
Powered by EzPortal