Welcome Guest!!!

Thank you for visiting the GM Kappa Performance Forum. This forum is the only performance oriented forum for all GM Kappa Platform Enthusiasts.  We hope you will join and share your experiences.  Becoming a member is FREE! If you want to advertise on this forum, email KappaPerformance at yahoo.com.

Registration required to view the forum attachments. Below is a sample of the current top 25 topics.
Supporting Membership has many advantages.

More information on becoming a supporting member or vendor can be found on the sub forum; Site Help and Suggestions; thread - Supporting Members and Vendors.
Pages: [1]   Go Down

Author Topic: DDM Stage III quasi test  (Read 2490 times)

0 Members and 1 Guest are viewing this topic.

Offline Critterman

  • Retired, thank you very much
  • Premium Member
  • General Manager
  • *
  • Posts: 13700
  • Karma: +18/-58
  • Baltimore/Washington Corridor
DDM Stage III quasi test
« on: April 07, 2009, 06:38:38 PM »
Okay, so I didn't do a full out run to red line at WOT because I didn't want to break the tires loose, but here is my first report:

Air temp:  47
Barometric pressure:110 kpa
Altitude:  <100'

5th gear @ 2200 RPM 3/4 throttle  10.2 and 10.6 lbs of boost
1st gear 4/5th throttle short shifting at 5k  13.6 lbs of boost.

I am pulling my boost at the supercharger not at the intake manifold, it would probably be a lb or so less there.
Logged
GONE: (but not forgotten) 2006 Cool named IXABEL (BISH-AH-BEL) Mayan for "Good Roads"
DDM StageIII intercooled Supercharger, Wisco ceramic coated pistons, Carrillo rods, superTech valves and Springs, Ported and polished head, Exedy Stage II Clutch,
big brake kit, slotted/drilled Rotors w/Porterfield pads & blue juice, Backbone, Probeam, Cross Strut Brace Underhood, trunk, & door Lights, ZOK suspension
JPM Center console, door inserts, & dash Seat bolster & lumbar support
Focuztech Tri-Y Header & hi-flow cat, Solo Performance SQR-2, Norm's Rear facia, Heated Seats, Blackface gau
Pages: [1]   Go Up
 
Powered by EzPortal