Haven't much felt like talking about it as I'm still SICK to my stomach over it & I still don't know what the hell I'm going to do now accept to let it sit for quite awhile.
After 12,000mi. & much fun since the SC install SOMETHING HAS GONE AFOWL INSIDE MY MOTOR... lost power during hard acceleration - all was good up through 3rd gear, then it shifted to fourth & continued to accelerate for just about a second then the power went away. I let out of it coasting down to a slower speed & RPM feeling something isn't right. With no indication of something wrong (no CEL, no strange noise) I tried to apply power again to see how it would respond... all the bells & lights went off & limp mode/reduced power engaged. I quickly checked my DashDaq for codes as I decelerated & it showed P0304 cylinder #4 misfire. I continued to decelerate/idle down (mind you I was going quite a fair speed when it happened) to a stop at an intersection & the engine was barely idling sounding like maybe only 1 cylinder was firing. I shut it off, cleared the codes to get it out of limp mode/reduced power mode then tried to start it again. Same thing, only running on 1 or 2 cylinders, just enough to get to a side street about a hundred yards up the road & wait for the tow truck. I knew it was all over at this point.
Got it home & immediately pulled #4 plug. It was fouled with oil... NOT GOOD! Pulled all other plugs & all others looked OK except for looking dark/sooty. NO PLUGS showed ANY indication of detonation. I screwed a compression tester into cylinder #4, turned it over & the needle didn't even twitch - 0 compression. I checked the next one over & it had 90psi. The next one had 115psi & #1 had 70psi. I pulled the valve cover & all valves/springs/keepers/guides & timing chain/gears looked OK & had full movement when engine turned over. Drained the oil & pulled the oil filter... found metallic residue in the oil & shavings in the filter. GAME OVER!

I'm not sure what went wrong, no sense in pulling the head since the whole thing has to come out for a complete rebuild or replacement anyway (metal in the oil & filter) so it might as well all be done at once. Don't know when I'll get to it now... $'s,$$$ is not in the bank or budget.
It was fun while it lasted...