Yea, I like the Viper but without the Jazz section. The Jazz makes it a little too busy.
Also, the scoop needs to be functional and tied into a CAI and sealed.
Frank I
Here is what I posted in the other thread before we closed it,
Well, here's my 2 cents on being functional. Almost all the hoods pictured would allow for air to get into the hood thus bringing temps down. Now as for them directing air right into the air box inlet, thats going to be a ton of work and considerably more expensive especially if I have to do one for each brand of cold air intake, plus the GXP and NA. Now I would have to get a NA car and a GXP car and do several sets of under hood ducting, plus I want one for my for my V8 car too. So if I went with my original idea of doing two styles of hood, I would end up with like 8 molds. 8 molds is considerably more money and work than I am looking to get into. If you guys would be happy with just getting air in, then I will only have three molds thus making it more reasonable. I can also have a outlet vent option that people could decide if they want, maybe similar to the transformer car and the ones I have on my car now..
A couple people have also said they do not want water to get under the hood while raining. That is workable if the car is just sitting still, but not workable if you are driving down the road and do not want any water to get in. It would be easy to seal the vents to have a non-functional hood and that could be an option.
So chime in again. Thanks!