Another simple DIY mod from the (increasingly disturbed) mind of TomatoSoup...
Was changing my oil today and again noticed how difficult it is to add new oil to the engine, with the awkward placement of the fill hole and shallow entry point. Regular funnels won't fit without being held.
So, in a moment of inspiration (actually while re-filling my washer fluid), I came up with this zero-cost and simple oil filler funnel that is PERFECTLY sized for the kappas...
First, find yourself an (ahem) empty cheapo windshield washer fluid bottle (or similar - see photo) and cut off the top with a sharp knife or scissors, preferably avoiding cutting yourself in the process:
[attachimg=1]
Dry the top out thoroughly, especially inside the handle. Then, using a heat source - I used a heat gun, but a gently applied propane torch would work too - heat the top and bottom of the handle piece until soft and crimp together with long-nose pliers from both sides so the handle is sealed off at top and bottom (no leaks please
):
[attachimg=2]
Cut through the 'merged' bits that you formed per the above, with a pair of wire-cutters or heavy scissors, and there you have it. Fits perfectly and hooks over the rubber seal lip of the hood so it stays in place - no hands. (I suggest you leave about 1/2" more length on the handle by the wide mouth than I did for a more secure 'hook'.)
[attachimg=3]
[attachimg=4]
