I've decided that one of my winter projects will be to install a Dejon Intercooler and pipes. Because I usually only do simple things on the car such as oil, differential, transmission fluid changes, change plugs etc, I want to make sure I'm not biting off more than I can chew here. Step 1 is to make sure I can get the fascia off and on again, which seems to be about 1/3 of the work required when doing the intercooler swap.
The first thing I did was read the service manual. The explanation was written for someone who knows what they're doing (mostly ruling me out!), but was a good start. Then I searched all the Solstice forums and found a couple of good post with pictures which also helped quite a bit. Then I grabbed a flashlight and crawled in and under the car. There are a few things that were sort of glossed over though, and I just KNOW that these little niggley things will bite me in the butt if I don't figure them out first. So I have 3 questions that may seem very simple to most of you, but keep in mind I've never taken the fascia off of any car I've ever owned, so if you're responding here, please type slow so that I can follow along.
Question #1 On the GXP there are brake cooling tubes that go from the fog light area and pass through the wheel liner. How are these disconnected? Do they just pull out of the liners when the fascia comes off, or do they need to be taken off of the fascia and left sticking into the wheel liners? I couldn't really see any fasteners that could be undone, so this one has me stumped.
Question #2 I crawled under the car to look at the retaining clips. side note - it appears there have been a few "incidents" and there are a lot of scratches under there

. Personally I am not a fan of plastic retaining clips, and have little or no experience with them. Are they reusable or should I purchase new ones? If I've bonked them on the pavement a couple of times, will they be shot when I pull them out, so I should plan to replace them anyway? IF I should replace them, does anyone know a part number for them? I can't find a part number anywhere.
Question #3 (this one is just to build my confidence)
There are quite a few people who have done this over the years. Are there any gotchas I may run into that most people do not talk about? ie, do you have an embarrassing experience with fascia removal you would like to share?
I noticed that we don't seem to have a How To in Joe's Garage for facia removal yet. I plan to do a practice run in a week or two, so I'll take some pictures along the way, and hopefully we'll end up with a How To that even rookies will be able to use. Thanks in advance to those that respond with their first hand knowledge / answers / embarrassing stories!